Fuel Injector Tester & Cleaner Kit is a specialized diagnostic device used to electronically switch and pulse gasoline fuel injectors. It is primarily used to identify blocked, leaking, or electrically defective injectors without requiring the vehicle to be running.
Key Features & Functions
Dual Voltage Output: Switchable between 5V and 12V, making it compatible with both standard EFI (12V) and modern GDi (5V) gasoline injectors.
4-5 Diagnostic Modes: Most versions include selectable pulse modes—Short, Medium, Long, and Continuous—to simulate various engine conditions such as idling or full load.
Safety Protections: Built-in reverse polarity and output short-circuit protection to prevent damage to the tool or the injector.
Cleaning Aid: When used with a pressurized aerosol cleaner, the tool helps flush out carbon deposits and varnish from the injector.
Technical Specifications
Feature
Specification
Power Source
12V Vehicle Battery
Output Pulse
Switchable 5V / 12V
Pulse Frequency
1 - 100Hz (Variable by mode)
Pulse Width
1 - 50ms (Approx.)
Compatible Fuel
Petrol Only (Not for Diesel)
The Automotive Fuel Injector Tester is a handy tool created to help you find and solve problems with injectors in gasoline cars. This tester lets you
check each injector on its own to spot problems like sticking, leaking, or burnt-out issues. It works using a 12V car battery and gives precise result
Note to Buyer (s): Test fuel injector with any pressure gauge for gasoline cars; not for diesel engines.
Operating Instructions
Switch off the car's engine.
Disconnect the wire plug from the fuel injector that needs testing. Then, link the instrument's pulse output terminals to the vehicle's fuel injector.
Attach the red clip of the instrument to the positive terminal of a 12V car battery, and attach the black clip of the instrument to the negative terminal of the battery.
Press the "Mode set" key to choose the pulse signal output mode you need, and the screen will show the mode you've selected. (Below, you'll find an explanation of the various modes. To stop the pulse output, press the "Pulse" key once more.)
Once you've chosen the pulse signal mode you need, just press the "Pulse" button. This will send pulses to the fuel injector being tested, and the signal light will turn on when the pulses are sent.
After finishing the test, press the "Pulse" keyagain to repeat the test. To switch the pulse mode, press the "Reset"key. You can freely choose the desired mode and activate the fuel injector.
